Delta LF350 rectifier with reinforced column complete with magnetic plane 150 x 300 new reconditioned machine and adequate characteristics • Base and column holder and arm arm: made of monolithic cast iron merger of the best quality with ribs in the points subjected to the greatest stresses, in order to allow maximum stiffness to the head Mola. • Testa engine door Mola: consisting of a special three -phase fan engine externally and dynamically balanced, whose large -sized spindle rotates on special bearings suitable for high speeds, with automatic shooting recovery. • Column: cast iron melted, caught on the appropriate arm by means of large -screened large conical rollers, to allow maximum stiffness to the flexions. • Quick vertical advancement: it is obtained by means of a graduated flyer that acts on a pair of helical gears, in order to allow an advancement of 2 mm on each lap. • Vertical micrometric advancement: by means of a night on the drum of the flyer; It can be grafted or deceived, allowing direct readings on the non -flyer of 0.01 mm. Accessories supplied • refrigeration system with electric pump • Mola complete with cup Mola • Protection Carter • Service key • Electrical system with newly low voltage controls • Permanent magnetic plane 300 x 150 New • Mola with new technical data Art. Quick for each lap of flyer 2 mm micrometric advancement by means of 0.01 mm Note of the MOLA size 200x80x78 mm Giri Mola per minute N. 2,800 MOLA POWER 4 HP power power electroP downside 0.15 HP Frequency 50 Hz Power supply 220/380V three -phase size 1000x880x1.750 mm net weight kg 550